在使用超聲波的過程中，經常會遇到一些問題，比如超聲波清洗機的指示燈亮，但是沒有超聲波輸出，這究竟是什么原因呢？in the process of using ultrasonic, we often encounter some problems, such as the indicator light of ultrasonic cleaning machine is on, but there is no ultrasonic output. what is the reason?
一、換能器出現故障
1、 transducer failure
出現這種問題很可能是超聲波清洗機換能器出現故障，操作人員應該查看換能器與超聲波功率板的連接插頭，看看插頭是否松脫。超聲波換能器是比較容易受潮的，通過檢查，如果不是因為受潮而不能正常工作，那么很可能是換能器損壞了，要及時更換新的換能器。
this problem is likely to be caused by the failure of the transducer of the ultrasonic cleaning machine. the operator should check the connecting plug between the transducer and the ultrasonic power board to see if the plug is loose. the ultrasonic transducer is relatively susceptible to moisture. through inspection, if it is not because of moisture and can not work normally, it is likely that the transducer is damaged, and it is necessary to replace it with a new one in time.
二、換能器振子燒壞
2、 transducer vibrator burnt out
出現這種問題也可能是換能器振子脫膠，導致振子和振動面連接不好，最終燒壞振子。操作人員是可以用萬用表來檢測振子是否出現斷路，如果燒壞要及時維修。
this problem may also be caused by the degumming of the transducer vibrator, resulting in poor connection between the vibrator and the vibrating surface, and finally burning the vibrator. the operator can use a multimeter to detect whether the vibrator is open circuit. if it is burnt out, it should be repaired in time.
除此之外，還有可能是穩壓管損壞，或者是電感以及隔離變壓器被燒毀。出現這種問題，超聲波清洗機操作人員一定要查明原因，及時解決。
in addition, there may be damage to the regulator, or the inductance and isolation transformer may be burned. in case of such a problem, the operator of the ultrasonic cleaning machine must find out the cause and solve it in time.
以上就是為大家介紹的有關全自動超聲波清洗機的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以專業的態度,為您提供服務
the above is a detailed introduction about the full-automatic ultrasonic cleaning machine for you. i hope it can help you. if you have any questions, please contact us. we will provide services for you with a professional attitude
關鍵詞：超聲波清洗機 超聲波換能器 變壓器 全自動超聲波清洗機